Broseley eVolution 7 Insert Instrucciones de operaciones descargar pdf (Pagina 21)

Smoke Exempt Requirements

eVo 7 Inset - Ignition

The procedure adopted for ignition is to build a bed of embers in stages with the objective of

warming the stove as quickly as possible. Firstly, a double handful of kindling (equivalent to the

weight of about 1 kg) should be lit with chemical fire-lighters. The primary air and secondary air

controls must be fully open at this stage. The fire door needs to be pushed against the latch but

not closed, leaving a gap of a few millimetres. After about 8 minutes, with the fire bed dying back, 3

half sized logs (total weight about 1.2 kg) should be added with the air controls unaltered. After

approximately a further 2 minutes, when these logs are well alight the door and primary air supply

can be closed. Then allow the fire to burn down to embers with the secondary air supply

maintained at maximum, at which point the ignition sequence is deemed to have ended.

Evo 7 Inset - Refuelling

The refuelling procedure adopted for the PD6434 tests allows the newly charged fuel to burn with

the door set on the latch but not closed, the primary control set fully open for 1 2 minutes and the

secondary air set in the required positions necessary for the various outputs. After 1 2 minutes,

with the logs burning well, the door and primary air supply needs to be closed but the secondary air

control position can remained unaltered. The tertiary air supply is maintained with its permanent

opening throughout.

Evo 4 Inset – Ignition

The procedure adopted for ignition is to build a bed in stages and to warm the body of the

appliance and the chimney as quickly as practicable. Firstly kindling, weighing approximately 1 kg

will need to be lit (using a chemical fire-lighter is recommended) with the air control fully open. The

door must be pushed against the appliance but then left ajar. After about 10 minutes, when the fire

from the kindling is beginning to die back, two small logs can be added. When these are alight and

fully blackened, the door can be closed. This, typically, takes approximately a further five minutes.

When the fire is again beginning to die back, a full load of two logs, weighing about 1.3 1.4 kg,

can be added: typically this takes 20 – 25 minutes from the start of the ignition sequence. The

Secondary air control must be maintained in its fully open position for the remainder of the ignition

sequence. Once the fuel has blackened the fire can then be allowed to burn down to a suitable

condition at a preferable air slider position. For start of further re fuelling apply sequence in the

previous 2 sentences.

Evo 4 Inset – Refuelling

There is a requirement for the door to be left ajar for 3 minutes immediately after refuelling. This is

to ensure that flames are well established on the newly charged logs and that they become fully

blackened. Additionally, for medium and low output burning, the Secondary air control must be

Maintained at 100% open for the first 3 minutes after refuelling at which time it is possible to adjust

to the required settings as identified above. The primary air intake is not required at this stage.

MS11-11 Issue 3 21

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 29 30

Sin comentarios

Broseley eVolution 7 Insert Instrucciones de operaciones Pagina 21